Guide · Homeowners · 3 min read · Updated 17 November 2026
Integral Garage Fire Separation: Walls, Doors and Ceilings
Short answer
The walls and ceiling between an integral or attached garage and the house should provide fire resistance, typically 30 minutes, with any door between them a self-closing fire door. Pipes and cables passing through must be fire stopped. Approved Document B covers this for building work in England. Upgrading an existing wall costs £35–£65 per m², and a new 30 minute partition £55–£85 per m².
Why garages need fire separation
Garages carry a higher fire risk than living space. They often contain cars, fuel, garden machinery, paint, solvents, bikes with batteries and electrical equipment such as chest freezers or chargers. Fires that start in garages can spread quickly and produce dense smoke. Separating the garage from the house slows the spread and gives occupants time to escape.
Approved Document B of the Building Regulations in England expects the walls and floors separating a garage from a house to be fire resisting. The same thinking applies when you convert part of a garage, build a room over a garage or create a new door from the garage into the house.
What typically needs to be fire rated
For a typical house with an integral or attached garage, the elements below are normally expected to provide fire separation. Your building control body will confirm the details for your situation.
| Element | Typical requirement | Notes |
|---|---|---|
| Wall between garage and house | 30 minutes fire resistance | Must run to the roof or the floor above |
| Ceiling under a room above | 30 minutes fire resistance | Protects the bedroom or room over the garage |
| Door between garage and house | Self-closing fire door | Typically FD30 with a self-closing device |
| Pipes and cables through the wall | Tested fire stopping | Collars, sealant or batts as specified |
| Loft void above garage | Separation continued | No gap allowing fire into the house roof |
Common gaps in fire separation
Many garages that look separated have hidden weaknesses. The separating wall may stop at the garage ceiling, leaving an open loft void that runs straight across into the house roof space. A previous owner may have swapped the fire door for an ordinary internal door or removed the closer because it was inconvenient. New cables, boiler flues and waste pipes may have been run through the wall without fire stopping.
Ceilings below bedrooms over garages are another common issue. Old plasterboard ceilings may have been damaged, patched with standard board, or cut for downlights, reducing their fire resistance.
- Check the separating wall continues into the loft and up to the roof
- Look for unsealed holes around pipes, cables and ducts
- Confirm the connecting door is a fire door and closes by itself
- Inspect the garage ceiling for damage, gaps or recessed lights
- Look for loft hatches in the garage ceiling that are not fire rated
How a specialist upgrades garage separation
The installer starts by surveying the wall, ceiling and roof void. Where the existing wall is sound masonry, the main work is often in the loft, building up the separation to the underside of the roof, and fire stopping penetrations. Where the wall is a stud partition, additional fire-resistant board is fixed to a tested upgrade specification at £35–£65 per m².
The ceiling below a room over the garage can be overboarded with fire-resistant board or replaced. Recessed light fittings are either removed, replaced with fire rated fittings, or fitted with fire hoods. Service penetrations are sealed with intumescent sealant, fire collars or batts. A fire door with a self-closing device is fitted between the garage and house, with a matching frame.
Garage conversions and rooms above
When a garage is converted into a habitable room, the fire separation question changes. If the whole garage becomes living space, the separating wall is no longer between a garage and the house, but building regulations still apply to the conversion, including insulation, ventilation, escape and fire safety. If only part of the garage is converted, the wall between the remaining garage and the new room needs to be fire separated.
Building a room over a garage requires the floor between them to be fire resisting, and any steel beams supporting the new room may need fire protection boxing at £250–£600 per beam.
Is it worth upgrading an older house?
Building regulations apply when you carry out building work, so they do not normally force you to upgrade an existing garage. Even so, it is sensible to check the separation, especially if bedrooms are above or next to the garage. Simple steps such as fitting a proper fire door with a closer and sealing open penetrations are relatively low cost and make a real difference. Your home insurer may also have expectations, particularly if you store fuel or charge electric vehicles or e-bikes in the garage.
Electric vehicles, e-bikes and batteries
Many households now charge electric cars, e-bikes and e-scooters in the garage. Lithium-ion battery fires can be intense and produce large volumes of toxic smoke, which makes good separation between the garage and the house more important than ever. Charging equipment for cars should be installed by a qualified electrician, and portable batteries should be charged using the manufacturer's charger and not left charging unattended overnight.
If you charge vehicles or batteries in an integral garage, check the separating wall, ceiling and door with particular care. Fit a smoke or heat alarm in the garage that is linked to the alarms in the house, so a fire is detected early. Keep a clear route out of the house that does not pass through the garage. Keep the door data sheet and any certificate with your other house documents, as buyers' surveyors and building control may ask for them.
Questions people also ask
Does the door between my garage and house need to be a fire door?
For new building work in England, the door between an integral garage and the house is normally expected to be a fire door, typically FD30, with a self-closing device. If you are replacing the door in an existing house, fitting a proper fire door set with a closer is strongly advisable.
Does the ceiling of an integral garage need to be fire rated?
If there is a room above the garage, the ceiling and floor between them should provide fire resistance, typically 30 minutes. Damaged ceilings, standard board patches and unprotected recessed lights reduce that protection. Overboarding with fire-resistant board to a tested system is a common fix.
How much does it cost to fire separate a garage?
Upgrading an existing separating wall costs £35–£65 per m², while a new 30 minute partition costs £55–£85 per m². Fire stopping penetrations start from £25 each. A complete job including loft separation, ceiling upgrade and fire door is quoted after a survey of the garage.
Written and checked by the Fire Rated Walls team. Read our editorial policy.
More guides
How Much Does a Fire Rated Wall Cost in the UK?
A new fire rated stud partition in the UK typically costs £55–£85 per m² for 30 minutes and £75–£120 per m² for 60 minutes. Upgrading an existing…
30 vs 60 Minute Fire Rated Walls: Which Do You Need?
A 30 minute fire rated wall resists fire for at least 30 minutes, and is typical for protected stairways in houses, garage separation and many…
Loft Conversion Fire Protection: What the Rules Require
When a loft conversion adds a new storey to a typical house in England, Approved Document B normally requires a protected escape route from the new…
What Is Fire Stopping? Penetrations, Products and Rules
Fire stopping is the sealing of gaps and openings in fire resisting walls and floors, such as holes around pipes, cables and ducts, so fire and smoke…
Get a free fire rated walls quote
Tell us what you need and we'll come back with a clear price.
Request a quote