Fire Rated Walls

Fire Rated Walls

Fire Rated Stud Partitions

New metal or timber stud walls built to tested 30, 60 or 120 minute systems using fire-resisting plasterboard.

Free Fire Rated Walls quote

No obligation. We only use your details to reply about this job.

Fire Rated Stud Partitions — Fire Rated Walls

What's involved

Most fire rated partitions use galvanised steel studs and track, typically 70 or 92 mm, at 600 mm centres, though timber stud systems are also tested. The installer fixes head and floor tracks, then studs, following the manufacturer's system sheet exactly. Fire-resisting plasterboard, often 12.5 or 15 mm, is screwed at the specified centres. As a guide, one layer each side commonly achieves 30 minutes and two layers each side 60 minutes, but the exact build depends on the tested system. Mineral wool in the cavity may be required for the rating or for sound. Deflection heads allow for movement at the ceiling without opening a gap. Joints are taped and filled. A typical room partition takes one to three days. You need to confirm the rating required by your fire strategy or Building Control.

How we handle it

  1. Tell us the requirement

    Use the quote form to describe the building, the wall's purpose and the fire rating required. Drawings, Building Control notes or a fire risk assessment help us brief the right specialist.

  2. Survey and specification

    A local specialist surveys the existing construction, confirms the rating and selects a manufacturer's tested system. You receive a fixed written price.

  3. Install the wall system

    Studs, track and fire-resisting board are installed to the system sheet, with correct layers, screw centres, mineral wool and deflection heads.

  4. Fire stop penetrations

    Every pipe, cable and duct through the wall is sealed with tested fire-stopping products, labelled and photographed for the record.

  5. Record and hand over

    Joints are finished, and you receive details of the systems used plus photographic records to support Building Control or your fire risk assessment.

Price guide

Fire rated wall prices depend on the rating required, the wall area, how many penetrations need fire stopping and whether existing walls are being upgraded or new ones built. Higher ratings need more layers of board and more labour. Every quote is fixed after a survey and names the tested system to be used.

  • Fire stopping penetrations: from £25 per penetration. Collars, sealant, batts or wraps depending on pipe, cable or duct size.
  • 30 minute stud partition: £55–£85 per m². Metal stud with fire-resisting board each side, taped and filled, typical domestic build.
  • 60 minute stud partition: £75–£120 per m². Two layers of fire-resisting board each side with mineral wool where specified.

Questions about fire rated stud partitions

What is a fire rated wall?

A fire rated wall is a wall built to resist fire for a set time, such as 30, 60 or 120 minutes, measured in standard fire tests. It must keep its stability, stop flames and hot gases passing through, and limit temperature rise on the safe side. The rating only applies if the wall matches the tested system exactly.

How much does a fire rated wall cost?

A 30 minute metal stud partition typically costs £55 to £85 per square metre, and a 60 minute partition £75 to £120 per square metre. Upgrading an existing wall to 30 minutes with extra board costs around £35 to £65 per square metre. Fire stopping penetrations starts from about £25 each.

What plasterboard is used for fire rated walls?

Fire rated walls use fire-resisting plasterboard, usually pink or red, which contains glass fibres and additives that help the board hold together in a fire. Typical thicknesses are 12.5 and 15 mm. Standard plasterboard offers some resistance but is not used where a specific rating is required, because tested systems specify fire-resisting board.

Get a free fire rated walls quote

Tell us what you need and we'll come back with a clear price.

Request a quote